Continuity Kit

[crawdadric]

I installed an SE106 counter rotating drive and I noticed that the bottom starboard stud hole did not come with a continuity washer. I had a new Mercruiser Continuity kit in my tool box, so I used that. I found the self tapping screw mounting hole on the drive was larger then the screw that came with the kit.

What is the size for the phillip self tapping screw?
Thank you,
Crawdadric

[Tech Support]

You can either tap the hole 1/4-20 or use a 1/4 inch self tapping screw.

Tech Support