Search:

Type: Posts; User: Cresco750

Search: Search took 0.00 seconds.

  1. Replies
    12
    Views
    10,668

    A very belated follow up to this issue; I managed...

    A very belated follow up to this issue; I managed to get the drive to shift fairly reliably by slowing the engine idle right back so it was just ticking over - almost stumbling but not to the point...
  2. Replies
    12
    Views
    10,668

    I tried the old shaft from my MC1 drive and it...

    I tried the old shaft from my MC1 drive and it did line up straight although I found it wasn't a tight fit on the lower shaft splines and had a small amount of play. Shifting is a bit better but...
  3. Replies
    6
    Views
    2,750

    Ok, mine is off centre even more than yours;...

    Ok, mine is off centre even more than yours; maybe twice as much. One of the obvious issues it causes is that it makes installation of the outdrive difficult because the "foot" on the intermediate...
  4. Replies
    12
    Views
    10,668

    Any more thoughts or suggestions before I pull...

    Any more thoughts or suggestions before I pull the SEI drive off?
  5. Replies
    12
    Views
    10,668

    Unsure of the degrees off but I do know that when...

    Unsure of the degrees off but I do know that when I first installed the drive the intermediate shaft foot and upper shaft shoe were misaligned enough that I had to apply a small amount of force to...
  6. Replies
    12
    Views
    10,668

    I'm still having issues with my drive not going...

    I'm still having issues with my drive not going into neutral properly. I followed the directions you emailed me to the letter in the hope that this would solve the situation, but unfortunately it...
  7. Replies
    12
    Views
    10,668

    Problem Selecting Neutral -SE106

    Im having difficulty with selecting neutral in my newly installed SE106 complete drive. It is mated to an MC1 transom assembly / Merc 228.
    The lower shift cable is only about six months / 30hrs old...
Results 1 to 7 of 7

115 S. Forest Lakes Blvd.
Oldsmar, FL 34677

tel: 813.925.7127
fax: 813.925.7064


Sterndrive Engineering, Inc. (SEI) manufactures a stern drive designed to replace Mercury Marine's MerCruiserŽ Alpha OneŽ, R, MR, Gen II and Bravo OneŽ stern drives. MerCruiserŽ Alpha One, R, MR, Gen II and Bravo OneŽ are trademarks of the Brunswick Corporation. SEI has no affiliation with the Brunswick Corporation. Consequently, any warranties governing products and or sold by Brunswick Corporation will not apply to products manufactured and or sold by SEI, or to products damaged due to the operation of an SEI product.