Announcement

Collapse
No announcement yet.

SEI 116 assembly

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • SEI 116 assembly

    Ok when mating the upper unit to the lower unit is there any need to use a sealant?
    There was a small gap between the two at the very aft portion. About the last 3-4 inches.
    Not large just the thickness of a piece of paper. Enough to see light thru it.
    Also are all the O-rings in the gasket kit used? Or does it depend on your installation?

    Thanks
    Mark

  • #2
    No sealant between the halves. The only "seal" between the halves is the oring for the oil passage. The gap at the aft end is fine. You can use all the o-rings, but the one near the splines on the ujoint shaft will not serve any purpose unless you have a greasable coupler.

    Tech support

    Comment

    Working...
    X