Results 1 to 2 of 2

Thread: Remove drive shaft

  1. #1
    Join Date
    Oct 2017
    Posts
    1

    Default Remove drive shaft

    I am returning my SE 306 lower unit. Because the motor is old, I had to buy a new drive shaft. When I installed it, I just tapped it until it clicked. Now I can't remove the drive shaft. I have tried to drive it out but it doesn't move. How do I remove the SEI drive shaft from the SEI lower unit so I can return it?

  2. #2
    Join Date
    Nov 2006
    Posts
    661

    Default

    There is a tool that clamps on to the driveshaft and then pulls the shaft out. It just has to break the clip holding it. https://www.sterndrive.cc/product/om...ol_390706.html otherwise you pretty much have to disassemble the unit to remove it.

    Tech Support

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

115 S. Forest Lakes Blvd.
Oldsmar, FL 34677

tel: 813.925.7127
fax: 813.925.7064


Sterndrive Engineering, Inc. (SEI) manufactures a stern drive designed to replace Mercury Marine's MerCruiserŽ Alpha OneŽ, R, MR, Gen II and Bravo OneŽ stern drives. MerCruiserŽ Alpha One, R, MR, Gen II and Bravo OneŽ are trademarks of the Brunswick Corporation. SEI has no affiliation with the Brunswick Corporation. Consequently, any warranties governing products and or sold by Brunswick Corporation will not apply to products manufactured and or sold by SEI, or to products damaged due to the operation of an SEI product.