Announcement

Collapse
No announcement yet.

"O" ring on verticle shaft

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • "O" ring on verticle shaft

    I recently installed a SE 106, on the old unit there was an "O" ring groove on the verticle shaft below the splines, the new unit did not have this "O" ring groove so therefore I did not install a new "O" ring. Do the new units not require this "O" ring?

  • #2
    That is correct, new units do not require the o-ring. It was redesigned many years ago.

    Tech Support
    Brunswick Corporation is the original equipment manufacturer (OEM). Sterndrive Engineering, Inc. (or SEI) is not affiliated with the Brunswick Corporation and is not authorized to sell or service Brunswick products.

    Comment

    Working...
    X