Announcement

Collapse
No announcement yet.

121 lower

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • 121 lower

    just bought a New 121 lower from you should get it this Wednesday. I am replacing a 1990 Bravo one, and i will need to plug the oil passage hole in my new lower, can i use JB weld to seal the hole?

  • #2
    Yes, JB weld should work. The preferred method would be to tap it and use a set screw though.

    Tech Support

    Comment


    • #3
      121 lower

      what size of a tap and set screw do I need? I want to have it on hand before my lower unit arrives. I have already spent too much time off the water as it is, excited to go out again.

      Thanks

      Comment


      • #4
        I am not sure. If you have a tap and die set, you can just measure the hole and use the chart that came with the kit.

        Tech Support

        Comment


        • #5
          I have some better information for you. If you just use a 1/4-20 or 1/4-28 tap, it should work fine. Then just use a set screw, making sure to be flush or recessed with the top of the case. Also put some silicone on the threads to make sure and seal everything.

          Tech Support

          Comment

          Working...
          X