If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I have an Alpha Gen II, serial # OW873462. It's stamped a 1:62 ratio. I would like to change the gear ratio to 1:50, what is needed, do I need to change the driveshafts as well (different number of teeth, etc)?
You just need to change the gears, and the lower bearing on the driven gear. Everything else is the same. It is a good idea, the 1.50 is alot stronger than the 1.62.
Tweet
Comment