Announcement

Collapse
No announcement yet.

lower unit installation question

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • lower unit installation question

    I am in the process of installing the lower unit (SE106) and I am following the instructions precisely. However, I am able to slide the unit up relatively easily until the final centimeter, then it stops. I've wiggled the shift shafts and it seems to engage. Is it possible that the water tube isn't engaging completely? If it is just a tight fit, would it be acceptable to attach the nuts and tighten the rest of the way (1 cm approx)? Can you think of any other problems that I might be having?

  • #2
    Make sure the dowel pin at the rear of the lower unit is lining up with the hole in the upper. You might have to tap it down with a rubber mallet.

    Tech Support

    Comment

    Working...
    X