Announcement

Collapse
No announcement yet.

grease from tolerance ring?

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • grease from tolerance ring?

    hi, was greaseing gimble bearing and saw grease come
    from bottom of tolerance ring, is that normal or could
    the gimble bearing be pushed in to far passing the
    the gimble houseing grease hole? i lined up
    the hole on the houseing to the one on the bearing.

  • #2
    If you keep putting grease in, does it eventually come out the bearing? As long as it does that, it should be fine. The bearing cannot be installed too far, as it has a hard stop that it should be up against.

    Tech Support

    Comment


    • #3
      i only pumped about 5 times and than stoped
      when i saw it comeing from the bottom,
      where on the bearing should it come out?

      Comment


      • #4
        It a little hard to describe without a picture, but it will come out around the sheild. If you only did 5 pumps, I would keep trying to put more in. If it just keeps coming out from around the bearing, then you will need to pull it and verify that the slot in the tolerance ring is lined up properly.

        Tech Support

        Comment


        • #5
          yes, comes out of the bearing and still a little
          at the bottom of the tolerance ring.

          Comment

          Working...
          X