I have the SE106 (Alpha One) I store the boat on a lift. PLEASE tell me there is another way to flush the motor and outdrive without hanging off the ladder to install the ear muffs. Seems all other systems have an direct connect hose system. There has to be something for the SE106.
Announcement
Collapse
No announcement yet.
Flushing System
Collapse
X
-
There is no flushing system available for that style drive. I remember seeing in the past a set of ear muffs on a pole that would allow you to reach it from the top. I did a little looking, however I don't see anything available now. Maybe you can make something up. Also, I imagine you could make some sort of piping and valve system inside the boat to allow you to hook a garden hose up to feed the engine and then have the water coming from the drive diverted somewhere else. The risk with that would be more failure points. Maybe look at iboats.com forums. There might be someone there that has done it.
Tech Support
-
flushing, as in after each use
Nothing for these drives except muffs or in water. A system can be constructed with some T`s and valves and a additional bilge hose fitting.PVC may also be used.
you can pm me for my cell if I dont make this clear enough.Make sure the drive is low enough to pump water
Cut the inlet hose in a convenient spot.
1 to engine
2 shutoff valve
3 from outdrive
4,5 shutoff valves
W fresh water in, garden hose with the male end
D raw water overboard ,bilge hose and fitting
Normal operation 4,5 closed.
For flushing 2 closed, 4 open, 5 open
1----T---2----T----3
I I
4 5
I I
W D
1 to engine
wont let it post properly , below the 1st T is the shutoff #4, below the 2nd T is shutoff #5Last edited by Bt Doctur; 11-18-2011, 07:14 PM.
Comment
Comment