Does this wear look normal? Unit is installes in a merc I transom assembly.
I have a rhythmic vibration under load from the out drive, that has been there since install of a complete 106 unit. I can moderate it with trim but it does not ever completely go away.Vibration gets worse when turning. Gimbal bearing was new at install of outdrive and still feels flawless. Alignment is good. I associated the noise off this with the complaints that these units were noisy when new. But after a hundred hours it has not improved. 1.47 ratio behind a 260.
yoke.jpg
Thanks, Mike
I have a rhythmic vibration under load from the out drive, that has been there since install of a complete 106 unit. I can moderate it with trim but it does not ever completely go away.Vibration gets worse when turning. Gimbal bearing was new at install of outdrive and still feels flawless. Alignment is good. I associated the noise off this with the complaints that these units were noisy when new. But after a hundred hours it has not improved. 1.47 ratio behind a 260.
yoke.jpg
Thanks, Mike
Comment