Hi, I'm new to the forum. I would like to replace both upper and lower as a complete unit. My drive is a '68 or '69 120, serial 2415602. It has two lines to each trim cylinder and a single eyelet on the upper housing cover. The only difference I see right off the bat to your SE106 is a slightly different prop shaft. Can I use the SE106 with the shorter yoke? Will I require a different prop, thrust washer, etc? Will it bolt up to my gimbal housing? Sorry If this question has been covered, I searched a little but did not find a thread that addressed my particular setup.
Announcement
Collapse
No announcement yet.
Older Mercruiser 120 Compatible?
Collapse
X
Comment