Tweet
I just finished installing my se106. When I was tightening the 6 bellhousing bolts, I noticed that the gasket sealing area on the new outdrive at the top of the bellhousing was much smaller than on the old outdrive. It is so thin that I worry about it not sealing. I put a little permatex sealer just along that top edge just in case. Have you seen this or had an issue with this before? Should I worry about this? Everything else seemed to be good. And it seems to run and shift fine on the trailer, Now I am just waiting to take her out on the lake.
-
-
We have not had any problems with this in the past. You should be just fine.
Tech SupportBrunswick Corporation is the original equipment manufacturer (OEM). Sterndrive Engineering, Inc. (or SEI) is not affiliated with the Brunswick Corporation and is not authorized to sell or service Brunswick products.
Comment