Installed my 106 today... - SEI Forums

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

X

Grady 75

Junior Member

Join Date: Jun 2009

Posts: 10
- Share
- Tweet
#1

Installed my 106 today...

07-21-2009, 10:04 PM

okay, so I install my drive today. Have to say the assembly of the two halves and installation went very easy. Put the gear oil in. Then realized I needed to use the rear pivot pin shaft off my old drive to connect the trim cylinders. I could not get it out of the old drive.....had to stop there. Needless to say I will be ordering a pivot pin. . The drive is ready to go once I install the pin. Then I can begin the "break in" period.....will keep all posted

1975 Grady White
165hp Mercruiser
Tags: None
270win

Junior Member

Join Date: Jul 2009

Posts: 2
- Share
- Tweet
#2

07-21-2009, 10:14 PM

did you get any pics of the work?
Comment
Grady 75

Junior Member

Join Date: Jun 2009

Posts: 10
- Share
- Tweet
#3

07-21-2009, 10:16 PM

sorry forgot.....but can take pics of drive already on boat without the trim cylinders attached....will post tomorrow for you.

1975 Grady White
165hp Mercruiser
Comment
Grady 75

Junior Member

Join Date: Jun 2009

Posts: 10
- Share
- Tweet
#4

07-22-2009, 01:21 PM

how can you post an image on this site?

1975 Grady White
165hp Mercruiser
Comment
Tech Support

Administrator

Join Date: Sep 2006

Posts: 551
- Share
- Tweet
#5

07-22-2009, 05:13 PM

When you are replying, click on the paperclip. This will allow you to attach the picture like in an email.

Tech support
Comment

Previous template Next

Working...

X