Announcement

Collapse
No announcement yet.

where does this go

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • where does this go

    OK I want to install my new drive but don't remember where the large rubber gasket goes. It would be the one that goes around the round part of the drive that goes into the gimbal. I need to know if it goes to the rear or the front of the drive.

  • #2
    You want to install that o-ring into the bell housing, up against the ledge that is 4 inches or so inside. It is best to glue it in with a little weather strip adhesive, so when you install the drive it doesn't get pushed intotbe bellows by the input yoke.

    Tech Support

    Comment

    Working...
    X