Tweet
I will be ordering the 90-306-B with upper drive shaft and water pump. Is there a tech sheet for this unit and install guide? What is different about the 2 part shaft? With the lower shaft installed are the shimms, bearing and seal installed also for upper shaft? Do you push the shaft down through Bearing housing(8438963) thrust washer and shims ?
-
-
You don't mention what year your motor is, but everything from Johnson / Evinrude 1992 and newer uses the two piece shaft. The lower shaft is already installedin our lower unit. The uppershaft then gets insterted into our unit and tapped down with a hammer to make sure it clips in. You do not need to dissasemble our unit in anyway to put the shaft in, so you will not need to worry about shimming or anything.
You also would need to reuse your shift shaft and if you are buying a new waterpump, make sure and copy your old water pump configuration. The water pump kit is universal, so it comes with a couple different styles of water tube connectors.
We don't have an install guide for it yet, but feel free to call us with any questions.
Tech Support -
Thank you so very much. Placing order tomorrowComment
Comment