Results 1 to 3 of 3

Thread: sei install question

  1. #1
    Join Date
    Jun 2015
    Posts
    4

    Default sei install question

    i am doing the cobra conversion with the SEI 116 and the conversion kit. the question is, i don't see any mention of the o ring kit that comes with it. nothing in the instructions. what are they for? and i read if you buy the conversion kit and the upper and lower, they modify it to fit?
    Last edited by Kfc282000; 06-27-2015 at 06:57 PM.

  2. #2
    Join Date
    Jun 2015
    Posts
    4

    Default

    never mind found the videos on you tube. that should be the official instructions..

  3. #3
    Join Date
    Jun 2015
    Posts
    4

    Default

    Have at least 8 hrs on the new outdrive. So far everything is going good. Nice unit. Had to get the new shifter as suggested by SEI. Very nice piece. The only thing I have a problem with, is the white wire. Tried the boat for a couple hours. Then installed the wire. No difference in shifting. Backed the idle down and it works good.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

115 S. Forest Lakes Blvd.
Oldsmar, FL 34677

tel: 813.925.7127
fax: 813.925.7064


Sterndrive Engineering, Inc. (SEI) manufactures a stern drive designed to replace Mercury Marine's MerCruiserŽ Alpha OneŽ, R, MR, Gen II and Bravo OneŽ stern drives. MerCruiserŽ Alpha One, R, MR, Gen II and Bravo OneŽ are trademarks of the Brunswick Corporation. SEI has no affiliation with the Brunswick Corporation. Consequently, any warranties governing products and or sold by Brunswick Corporation will not apply to products manufactured and or sold by SEI, or to products damaged due to the operation of an SEI product.