If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I am trying to replace the water pump on my se106. The impeller will not come loose it will move about 1/8 inch up but just locks up and I cannot remove it. Ideas?
There is a slight burr on the shaft just above the impeller rubber. Try gently tapping with a chisel to raise it up and off, then clean up the burr.Otherwise Dremel it off.
Tweet
Comment