If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
fresh or salt makes a difference,
Alpha1 trim tab, transom annode bolts, zinc block under mer-cathode ,trim cyl. shafts Series 1 optional,trim cyl. end caps, Horseshoe zinc GEN II
Basically you have one anode at the bottom of the gimble housing at each side. There is another anode where the trim lines hook up on the gimbal housing. The trim cylinders may also have an option for a u shaped anode on the endcap. There is also an anode above the prop that usually looks like a fin, but could be a flat plate if needed for prop clearance. The last anode is also optional if you have a newer unit, and that would be behind the prop mounted to the bearing carrier.
Comment